Arris C4C - Terminal Length

Chapter 46: Command Line Descriptions
STANDARD Revision 1.0 C4® CMTS Release 8.3 User Guide
© 2016 ARRIS Enterprises LLC. All Rights Reserved. 3057
terminal length
Purpose
Sets the number of lines for pagination of the console port. A value of zero indicates no pagination.
Default Access Level
1
Command Syntax
terminal length <number of lines>
terminal length [<number of lines>] no
Supplemental
Information
Non-zero values are only applicable for transports that do not support window size negotiation (serial, ssh). Transports which
support window size negotiation (telnet) may override this parameter. For Telnet sessions, a value will enable non-zero
pagination.
To reset to the default, use the no option.
Parameters
<number of lines>
Sets the pagination length of the console port
Related Commands
configure line vty (page 2175)
configure pagination (page 2232)
show running-config interface cable-downstream (page 3023)