Arris C4C - Configure Router Isis Set-Overload-Bit

Chapter 46: Command Line Descriptions
STANDARD Revision 1.0 C4® CMTS Release 8.3 User Guide
© 2016 ARRIS Enterprises LLC. All Rights Reserved. 2476
configure router isis set-overload-bit
Purpose
To configure the router to signal other routers not to use it as an intermediate hop in their shortest path first (SPF) calculations, use
the set-overload-bit command in router configuration mode. It will cause the originate LSPs with the Overload bit set.
Default Access Level
15
Command Syntax
configure router isis set-overload-bit [<level-1 | level-2>]
configure router isis set-overload-bit [<level-1 | level-2>] no
Supplemental
Information
This bit will be set if the level-1 or level-2 database is running short of a resource such as memory.
To restore the default value, use the no option.
Parameters
[<level-1 | level-2>]
Specifies the type of adjacencies to be formed on this interface.