Chapter 23: IPv6
STANDARD Revision 1.0 C4® CMTS Release 8.3 User Guide
© 2016 ARRIS Enterprises LLC. All Rights Reserved. 729
IPv6 Show Commands
For more information refer to Command Line Descriptions in this manual for additional information.
To display a list of all commands that include the keyword ipv6, use the following command:
show all-commands | include ipv6
To display the IPv6 configuration for the interface
show ipv6 interface gigabitEthernet <6-7>/<0-7>
Sample output:
show ipv6 interface gigabitEthernet 17/0
gigabitEthernet 17/0.0
Admin State / Oper State : Up / IS
Link-local address : FE80::201:5CFF:FE31:4AC0/10
Global address(es) : 2001:CADA:F409:1700::2, subnet is 2001:CADA:F409:1700::/64
Joined group address(es) : FF02::1
FF02::2
FF02::1:FF31:4AC0
FF02::1:FF00:2
DHCP Relay Destination(s) : None
Maximum Transmission Unit (MTU) : 1500 bytes
ND reachable time : 3600000 ms
ND advertised retransmit interval : 0 ms
ND router advertisements are sent every : 600 sec
ND router advertisements lifetime : 1800 sec
Host address autoconfiguration : Statefull
To display help text for the parameters of the show ipv6 route command:
show ipv6 route ?
WORD - IPv6 network or host of interest
cable - Displays IPv6 routes for cable (sub)interface
cable-mac - Displays IPv6 routes for cable-mac (sub)interface
connected - Connected|
detail - Shows same routes in a non-abbreviated format
gigabitEthernet - Displays IPv6 routes for gigabit (sub)interface
include-inactive - Shows active and inactive routes; defaults to displaying only active routes
isis - Intermediate System to Intermediate System (IS-IS) routes
local - local routes
netmgmt - netmgmt routes
null - Displays IPv6 routes for null interfaces
ospf - Open Shortest Path First (OSPF)
pd - Prefix Delegation routes
To Next Page
Loading...
Need help?
General
