Arris C4C - Configure Interface Cable-Mac;Cable Load-Balance Group Init-Technique

Chapter 46: Command Line Descriptions
STANDARD Revision 1.0 C4® CMTS Release 8.3 User Guide
© 2016 ARRIS Enterprises LLC. All Rights Reserved. 1536
configure interface cable-mac * cable load-balance group * init-technique
Purpose
Defines the initialization technique for a restricted load-balance group.
Default Access Level
15
Command Syntax
configure interface cable-mac <mac> cable load-balance group <group> init-technique [unicast-ranging]
[reinit-mac] [broadcast-ranging] [ranging] [direct] [disable]
configure interface cable-mac <mac> cable load-balance group <group> init-technique [unicast-ranging]
[reinit-mac] [broadcast-ranging] [ranging] [direct] [disable] no
Supplemental
Information
Note: The parameter disable can not be used in conjunction with any of the other options.
To turn off restricted load-balancing for the specified restricted load-balance group, use the no option.
Parameters
<mac>
The MAC identifier. Valid numbers are 0-415.
<group>
Unsigned integer. Valid range is 1-4294967295
[unicast-ranging]
Perform unicast ranging on new channel before normal operation.
[reinit-mac]
Reinitialize the MAC.
[broadcast-ranging]
Perform broadcast initial ranging on new channel before normal operation.
[ranging]
Perform either broadcast or unicast ranging on new channel before normal operation.
[direct]
Use the new channel(s) directly without re-initializing or ranging.
[disable]
All bits will be set to 0 and no load balancing will be done for this group.