Arris C4C - Configure Interface Tengigabitethernet Flowcontrol Send

Chapter 46: Command Line Descriptions
STANDARD Revision 1.0 C4® CMTS Release 8.3 User Guide
© 2016 ARRIS Enterprises LLC. All Rights Reserved. 1964
configure interface tengigabitethernet * flowcontrol send
Purpose
Sets the parameters to send flow control information.
Default Access Level
15
Command Syntax
configure interface tengigabitethernet <slot/port> flowcontrol send <desired | on | off>
configure interface tengigabitethernet <slot/port> flowcontrol send no
Supplemental
Information
N/A
Parameters
<slot>/port>
RCM slot number/tengigabitEthernet port number.
Valid range for the C4 CMTS is <17-18>/<10>
Valid range for the C4c CMTS is <17>/<10>
desired
Directs that an auto negotiation of flow control take place with preference to process Pause frames (The port will process flow
control if the far end supports/sends it).
on
Directs the specified port to be enabled to send flow control.
off
Directs the specified port to be disabled from sending flow control to the far end.