Arris C4C - Show Cable Dsg Ds-Frequency-List

Chapter 46: Command Line Descriptions
STANDARD Revision 1.0 C4® CMTS Release 8.3 User Guide
© 2016 ARRIS Enterprises LLC. All Rights Reserved. 2643
show cable dsg ds-frequency-list
Purpose
Displays the provisioned downstream channel list frequencies.
Default Access Level
1
Command Syntax
show cable dsg ds-frequency-list [chllistindex]
Supplemental
Information
If the optional channelListIndex is present, then only those entries that belong to that list will be displayed.
Note: If a downstream channel frequency-list is not associated with an interface, then the list index will be preceded by an asterisk
(*). This is done to assist in identifying provisioning disconnects.
Parameters
[chllistindex]
Unsigned integer used to filter the downstream frequency list information. Valid values are 1 to 65535.