Arris C4C - Configure Interface Tengigabitethernet Isis Network Point-To-Point

Chapter 46: Command Line Descriptions
STANDARD Revision 1.0 C4® CMTS Release 8.3 User Guide
© 2016 ARRIS Enterprises LLC. All Rights Reserved. 2055
configure interface tengigabitethernet * isis network point-to-point
Purpose
Configures the IS-IS point-to-point network.
Default Access Level
15
Command Syntax
configure interface tengigabitethernet <slot>/<port>[.<0-254>]isis network point-to-point
configure interface temgigabitethernet <slot>/<port>[.<0-254>] isis network point-to-point no
Supplemental
Information
This command only applies when IPv6 is not used in the system.
To restore the default value, use the no option.
Parameters
<slot>/<port>[.<0-
254>]
RCM slot number/tengigabitEthernet port number[.subinterface number].
Valid range for the C4 CMTS is <17-18>/<10>[.<0-254>]
Valid range for the C4c CMTS is <17>/<10>[.<0-254>]