Arris C4C - Configure Interface Link-Aggregate Ipv6 Ospf Area

Chapter 46: Command Line Descriptions
STANDARD Revision 1.0 C4® CMTS Release 8.3 User Guide
© 2016 ARRIS Enterprises LLC. All Rights Reserved. 1906
configure interface link-aggregate * ipv6 ospf area
Purpose
Enables OSPF for IPv6 on the specified cable interface.
Default Access Level
15
Command Syntax
configure interface link-aggregate <0-9[.0-254]> ipv6 ospf area <word> [instance <int>]
configure interface link-aggregate <0-9[.0-254]> ipv6 ospf area [<word>] [instance <int>] no
Supplemental
Information
To disable, use the no option.
Parameters
<0-9[.0-254]>
LAG identifier <lag[sub interface]>
<word>
OSPF area ID. It can be specified as either an IP address or decimal value.
[instance <int>]
Integer. Controls selection of other routers on this link as your neighbors.