Arris C4C - Configure Cable Enable-Trap

Chapter 46: Command Line Descriptions
STANDARD Revision 1.0 C4® CMTS Release 8.3 User Guide
© 2016 ARRIS Enterprises LLC. All Rights Reserved. 1265
configure cable enable-trap
Purpose
Enables a cable modem trap reset.
Default Access Level
15
Command Syntax
configure cable enable-trap [cmonoff-notification] [cminit-ranging-notification]
[cminit-ip-notification] [cminit-reg-notification] [cmflap-notification]
configure cable enable-trap [cmonoff-notification] [cminit-ranging-notification]
[cminit-ip-notification] [cminit-reg-notification] [cmflap-notification] no
Supplemental
Information
To disable a cable modem trap reset, use the no option.
Parameters
[cmonoff-notification]
Sends a trap if a registered CM clears.
[cminit-ranging-
notification]
Sends a trap if a CM clears while ranging.
[cminit-ip-notification]
Sends a trap if a CM clears while getting IP.
[cminit-reg-notification]
Sends a trap if a CM clears while completing registration.
[cmflap-notification]
Sends a trap if a CM returns after dropping off (flapping).
Related Commands
show cable enable-trap (page 2649)
show logging trap (page 2983)