Arris C4C - Show Cable Load-Balance Policy

Chapter 46: Command Line Descriptions
STANDARD Revision 1.0 C4® CMTS Release 8.3 User Guide
© 2016 ARRIS Enterprises LLC. All Rights Reserved. 2667
show cable load-balance policy
Purpose
Displays the provisioning for the load balance policies in a table format.
Default Access Level
1
Command Syntax
show cable load-balance policy [<policy>]
Supplemental
Information
Since there is a good deal of provisioning for each policy and it is important to be able to see how the load-balance policy
provisioning differs from each other, the provisioning is displayed in a table format.
Note: If the policy number is provided, then the table is shown with only rules associated with the one policy. If no provisioning is
found for a provided policy number, then the show command will generate an error indicating that the policy number could not be
found. If no policies are provisioned, then an error is generated indicating no policies were found.
Parameters
[<policy>]
The policy number