To Next Page

To Previous Page

Chapter 46: Command Line Descriptions

STANDARD Revision 1.0 C4® CMTS Release 8.3 User Guide

configure access-list * udp

Purpose

Configures an extended Access Control List (ACL) on the CMTS if the protocol value is UDP.

Default Access Level

Command Syntax

configure access-list <ext-acl-num> <permit | deny> udp <src-ip> [src-oper] <dst-ip> [dst-oper] [dscp

<0-63>] [precedence <uint>] [tos <0-15>] [fragments]

configure access-list <ext-acl-num> <permit | deny> udp <src-ip> [src-oper] <dst-ip> [dst-oper] [dscp

<0-63>] [precedence <uint>] [tos <0-15>] [fragments] no

Supplemental

Information

To remove an extended ACL, use the no option.

Parameters

<ext-acl-num>

The numeric identifier of the access list This is a number from 100-199.

permit: Permits access if the condition is matched.

deny: Denies access if the condition is matched.

udp

If the protocol value is UDP, the C4 CMTS supports the additional optional parameter string [operator [port]] after both the

source and source-wildcard options. This function compares source or destination ports. Possible source operators can be: lt (less

than) gt (greater than), eq (equal), neq (not equal), range (inclusive range). If the operator is positioned after the source and

source-wildcard, it must match the source port. If the operator is positioned after the destination and destination-wildcard, it must

match the destination port. The range operator requires two port numbers. All other operators require one port number.

<src-ip>

This can be the {host <IP> | any | <IP> [mask]}

<dst-ip>

This can be the {host <IP> | any | <IP> [mask]}

Arris C4C User Manual

Questions and Answers: