To Next Page

To Previous Page

Chapter 46: Command Line Descriptions

STANDARD Revision 1.0 C4® CMTS Release 8.3 User Guide

[precedence

<uint>]

Match packets with given precedence value. Valid values are:

0 = routine - Match packets with routine precedence

1 = priority - Match packets with priority precedence

2 = immediate - Match packets with immediate precedence

3 = flash - Match packets with flash precedence

4 = flash-override - Match packets with flash override precedence

5 = critical - Match packets with critical precedence

6 = internet - Match packets with internetwork control precedence

7 = network - Match packets with network control precedence

[tos <0-15>]

Match packets with given TOS value.

[fragments]

Check non-initial fragment.

{eq <port> | gt

<port> | lt <port> |

neq <port> | range

<port1> | <port2>}

eq <port> — Match only packets on a given port number

gt <port> — Match only packets with a greater port number

lt <port> — Match only packets with a lower port number

neq <port> — Match only packets not on a given port number

range <port1> <port2> — Match only packets in the range of port numbers

[established]

Matches the established connections.

[urg]

Matches on the URG bit

[ack]

Matches on the ACK bit

[psh]

Matches on the PSH bit

[rst]

Matches on the RST bit

[syn]

Matches on the SYN bit

[fin]

Matches on the FIN bit

Arris C4C User Manual

Questions and Answers: