Arris C4C - Configure Reset Cable-Modem

Chapter 46: Command Line Descriptions
STANDARD Revision 1.0 C4® CMTS Release 8.3 User Guide
© 2016 ARRIS Enterprises LLC. All Rights Reserved. 2244
configure reset cable-modem
Purpose
Resets one or more cable modem(s) by specifying either the IPv4, IPv6 address(s) or MAC address(s).
Default Access Level
15
Command Syntax
configure reset cable-modem <ip_address | mac _address> [delete] [bonded] [offline] [reject] [vendor
<word>] [oui <word>] [all] [bonded-impaired]
Supplemental
Information
N/A
Parameters
<ip_address |
mac_address>
Either IPv4, IPv6 address or MAC address of the cable modem
[delete]
Deletes the requested CM(s)
[bonded]
Filters on bonded CMs
[offline]
Filters on offline CMs
[reject]
Filters on rejected CMs
[vendor <word>]
Filters on CMs for a specified vendor
[oui <word>]
Filters on CMs with specified OUI (most significant 3 bytes of Vendor MAC address)
[all]
Filters on all CMs
[bonded-impaired]
Filters on bonded CMs that are not functioning at full capacity