Arris C4C - Configure Cable Intercept Subscriber

Chapter 46: Command Line Descriptions
STANDARD Revision 1.0 C4® CMTS Release 8.3 User Guide
© 2016 ARRIS Enterprises LLC. All Rights Reserved. 1322
configure cable intercept * subscriber
Purpose
Creates a Legal Intercept Tap session for an individual subscriber.
Default Access Level
15
Command Syntax
configure cable intercept [userid <id>] [password <password>] [subscriber <mac> [<emable | disable>]
[userid <id>] [password <password>]
configure cable intercept [userid <id>] [password <password>] [subscriber <mac> [<emable | disable>]
[userid <id>] [password <password>] no
Supplemental
Information
This command and the show cable intercept command are secured by the same userids and authentication passwords
configured for the cTapMIB view in the SNMPv3 agent in the CMTS. This includes read/write permissions associated with the
userids. The CLI will prompt for the userid and authentication password when they are omitted in the command line.
To remove the LI tap session for a specified subscriber, use the no option.
Parameters
[userid] id>
SNMP User ID
[password
<password>]
SNMP Authentication Password
<mac>
Subscriber’s MAC address. Valid forms for a MAC address are:
xx.xx.xx.xx.xx.xx
xxxx.xxxx.xxxx
xxxxxxxxxxxx
Related Commands
show cable intercept (page 2658)