Arris C4C - CLI Commands for FQDN

Chapter 42: Fully-Qualified Domain Name (FQDN)
STANDARD Revision 1.0 C4® CMTS Release 8.3 User Guide
© 2016 ARRIS Enterprises LLC. All Rights Reserved. 1073
CLI Commands
Table 131. CLI Commands for FQDN
Purpose
CLI Command
To enable [disable] multicast FQDN polling:
configure ip fqdn-cache enable [no]
To configure static FQDN cache polling interval:
The NO version of this command restores the default value of
this poll-interval.
configure ip fqdn-cache poll-interval <time> [no]a
To configure a domain name in the DSG tunnel classifier:
The NO version of this command ignores all the optional
parameters and removes the entire row associated with the
given tunnel and classifier.
configure cable dsg tunnel <tunnelid> classifier
<classid> [priority <priority>] [source-network
<domain-name | a.b.c.d>] [dest-ip <a.b.c.d>] [dest-
port-range <dest-portstart-desportend>] [include-
in-dcd] [no]
Network-side Interfaces
To configure domain names in static IGMP layer 2 router joins:
To configure domain names in static IGMP layer 3 router joins:
The NO versions of these commands remove the provisioning
for the static-group and source.
configure interface {gigabitEthernet |
tengigabitEthernet} <slot/port> ip igmp static-
group <group> [source <domain-name | a.b.c.d>]
[no]
configure interface {gigabitEthernet |
tengigabitEthernet} <slot/port>.subInterface ip
igmp static-group <group> [source <domain-name |
a.b.c.d>] [no]
Note: All Layer3 join commands MUST include the subInterface number. This applies even to the ".0".
Cable-side Interfaces (layer 2 joins)
To configure domain names in static IGMP layer 2 router joins:
The NO versions of these commands remove the provisioning
for the static-group and source.
configure interface cable-mac <macId> ip igmp
static-group <group> [source <domain-name |
a.b.c.d>] [no]
configure interface cable-downstream <slot>/<port>
ip igmp static-group <group> [source <domain-name |
a.b.c.d>] [no]