Arris C4C - Configure Interface Gigabitethernet Isis Hello-Interval

Chapter 46: Command Line Descriptions
STANDARD Revision 1.0 C4® CMTS Release 8.3 User Guide
© 2016 ARRIS Enterprises LLC. All Rights Reserved. 1819
configure interface gigabitethernet * isis hello-interval
Purpose
Computes the hello interval based on the hello multiplier so that the resulting hold time is 1 second.
Default Access Level
15
Command Syntax
configure interface gigabitethernet <slot>/<port>[.<0-254>] isis hello-interval <10-600000> <level1 |
level2>
configure interface gigabitethernet <slot>/<port>[.<0-254>] isis hello-interval [<level1 | level2>] no
Supplemental
Information
N/A
Parameters
<slot>/<port>[.<0-
254>]
RCM slot number/gigabitEthernet port number[.subinterface number].
Valid range for the C4 CMTS is <17-18>/<0-9>[.<0-254>]
Valid range for the C4c CMTS is <17>/<0-9>[.<0-254>]
<10-60000>
Specifies the milliseconds between hello packets (before multiplier)
[<level1 | level2>]
Specifies the type of adjacencies to be formed on this interface. If no value is specified, then modify value for both level-1 and level-
2.