Arris C4C - Show All-Commands

Chapter 46: Command Line Descriptions
STANDARD Revision 1.0 C4® CMTS Release 8.3 User Guide
© 2016 ARRIS Enterprises LLC. All Rights Reserved. 2622
show all-commands
Purpose
Displays the available CLI commands. This command is extremely helpful when looking for specific commands.
Default Access Level
1
Command Syntax
show all-commands [modal]
Supplemental
Information
Note: This command generates extensive output. It is recommended that you use a filter to refine your output.
Filtering the show all-commands — Following is the output listing the choices available for filtering:
C4>show all-commands | ?
count Only count lines that match, no display
page Only lines that match with pagination
begin Begin with the line that matches
exclude Exclude lines that match
include Include lines that match
until Display until line that matches
Parameters
[modal]
Displays only the configure modal commands.