Arris C4C - Configure Interface Gigabitethernet Isis Circuit-Type

Chapter 46: Command Line Descriptions
STANDARD Revision 1.0 C4® CMTS Release 8.3 User Guide
© 2016 ARRIS Enterprises LLC. All Rights Reserved. 1816
configure interface gigabitethernet * isis circuit-type
Purpose
Configures the level of adjacency for the specified interface.
Default Access Level
15
Command Syntax
configure interface gigabitethernet <slot>/<port>[.<0-254>] isis circuit-type <level1-enum2>
configure interface gigabitethernet <slot>/<port>[.<0-254>] isis circuit-type no
Supplemental
Information
The Level 1 adjacency may be established if there is at least one area address in common between this system and its neighbors.
To reset the circuit type, use the no option.
Parameters
<slot>/<port>[.<0-
254>]
RCM slot number/gigabitEthernet port number[.subinterface number].
Valid range for the C4 CMTS is <17-18>/<0-9>[.<0-254>]
Valid range for the C4c CMTS is <17>/<0-9>[.<0-254>]
<level1-enum2>
Specifies the type of adjacencies to be formed on this interface. Valid range is level-1, level-1-2, or level-2. If no value is specified,
then value is set to level-1-2.