Arris C4C - Show Running-Config Interface Tengigabitethernet

Chapter 46: Command Line Descriptions
STANDARD Revision 1.0 C4® CMTS Release 8.3 User Guide
© 2016 ARRIS Enterprises LLC. All Rights Reserved. 3030
show running-config interface tengigabitethernet
Purpose
The show running-config interface command shows the parameters for the specified tengigabitEthernet interface.
Default Access Level
15
Command Syntax
show running-config interface tengigabitethernet <slot/port> [verbose] [linenum] [full]
Supplemental
Information
N/A
Parameters
<slot>/<port>
The slot in which the targeted module resides. The slot must contain an RCM.
Valid range for the C4 CMTS is <17-18>/<10>
Valid range for the C4c CMTS is <17>/<10>
[verbose]
Displays the output with ‘configure’ on each line.
[linecard]
Enumerates each line with its line number in the output.
[full]
Displays all configuration values, including default values.