Chapter 46: Command Line Descriptions
STANDARD Revision 1.0 C4® CMTS Release 8.3 User Guide
© 2016 ARRIS Enterprises LLC. All Rights Reserved. 1457
configure diag
Runs diagnostics on the specified module.
configure diag <0-20> [factory | isolate | quick] [bist <> | bus <> | checksum <> | datapath noise |
debug <> | device <> | function {ersm | led} | loopback <> | memory <> | monitor <> | parity <> |
register <> | repeat <1-2147483647>]
configure diag <0-20> previous
The module must be taken out of service before you use this command.
The factory, isolate, and quick parameters can be used in conjunction with other parameters (except previous), but not with
each other.
Parameters
The slot number upon which to run the diagnostics.
Runs the "factory" diagnostics. This will impact service, depending upon your configuration.
Runs a "verbose" diagnostic to isolate problems. ARRIS recommends using one of the secondary parameters with this option.
Runs built-in self-tests for a specific component. Type configure diag <0-20> bist ? to list available components.
Tests a specific bus (communication system). Type configure diag <0-20> bus ? to list available buses.
Tests a specific EEPROM (non-volatile memory) component. Type configure diag <0-20> checksum ? to list available EEPROMs.
Tests the connection between devices, including the power level on upstream and downstream channels.
Provides additional information in a particular area or enables specific testing behavior. Type configure diag <0-20> debug ? to
list available options.
Narrows testing to a specific component. Type configure diag <0-20> device ? to list available devices.
To Next Page
Loading...
Need help?
General
