Arris C4C - Page 1458

Chapter 46: Command Line Descriptions
STANDARD Revision 1.0 C4® CMTS Release 8.3 User Guide
© 2016 ARRIS Enterprises LLC. All Rights Reserved. 1458
function {ersm |
led}
Tests the ERSM or light-emitting diode (LED) systems, respectively.
loopback <>
Narrows testing to the loopback interface between the CPU and specific devices on the module. Type configure diag <0-20>
loopback ? to list available devices.
memory <>
Narrows testing to a specific memory component on the modules. Type configure diag <0-20> memory ? to list available
components.
monitor <>
Tests a component that supports a monitoring function, such as temperature monitoring. Type configure diag <0-20> monitor
? to list available components.
parity <>
Tests a memory component's parity. Type configure diag <0-20> parity ? to list testable memory components.
previous
Show the results of the last diagnostic test run on the module.
register <>
Narrows testing to registers specific to a device. Type configure diag <0-20> register ? to list available registers.
repeat <1-
2147483647>
Number of times to perform the diagnostic test (loop).