Chapter 14: Cable-side Configuration
STANDARD Revision 1.0 C4® CMTS Release 8.3 User Guide
© 2016 ARRIS Enterprises LLC. All Rights Reserved. 394
Channel to MAC Domain Association
Channels in the CMTS must be assigned to a MAC domain in order to provide service. The MAC domain uses the channels
to transport signaling and data to the CMs.
The commands in this section bind a logical upstream or downstream channel with a MAC Domain. The ARRIS CMTS will
assign a default channel ID for each channel but the user may provision a channel ID (DCID or UCID) to the channel for use
in channel signaling.
These commands associate a downstream channel from an XD CAM or a logical upstream channel from a 12U or 24U CAM
to a logical MAC domain. See example below.
configure interface cable-downstream <WORD> cable cable-mac <mac> [no]
configure interface cable-upstream <WORD> cable cable-mac <mac> [no]
Example of associating XD CAM downstreams to 12U or 24U upstreams:
configure interface cable-downstream 14/0 cable cable-mac 1
configure interface cable-downstream 14/1 cable cable-mac 1
configure interface cable-downstream 14/2 cable cable-mac 1
configure interface cable-downstream 14/3 cable cable-mac 1
configure interface cable-downstream 14/4 cable cable-mac 2
configure interface cable-downstream 14/5 cable cable-mac 2
configure interface cable-downstream 14/6 cable cable-mac 2
configure interface cable-downstream 14/7 cable cable-mac 2
configure interface cable-downstream 14/8 cable cable-mac 3
configure interface cable-downstream 14/9 cable cable-mac 3
configure interface cable-downstream 14/10 cable cable-mac 3
configure interface cable-downstream 14/11 cable cable-mac 3
configure interface cable-downstream 14/12 cable cable-mac 4
configure interface cable-downstream 14/13 cable cable-mac 4
configure interface cable-downstream 14/14 cable cable-mac 4
configure interface cable-downstream 14/15 cable cable-mac 4
configure interface cable-upstream 1/0.0 cable cable-mac 1
configure interface cable-upstream 1/1.0 cable cable-mac 1
configure interface cable-upstream 1/2.0 cable cable-mac 1
configure interface cable-upstream 1/3.0 cable cable-mac 2
configure interface cable-upstream 1/4.0 cable cable-mac 2
configure interface cable-upstream 1/5.0 cable cable-mac 2
configure interface cable-upstream 1/6.0 cable cable-mac 3
configure interface cable-upstream 1/7.0 cable cable-mac 3
configure interface cable-upstream 1/8.0 cable cable-mac 3
configure interface cable-upstream 1/9.0 cable cable-mac 4
configure interface cable-upstream 1/10.0 cable cable-mac 4
configure interface cable-upstream 1/11.0 cable cable-mac 4
To Next Page
Loading...
