Chapter 14: Cable-side Configuration
STANDARD Revision 1.0 C4® CMTS Release 8.3 User Guide
© 2016 ARRIS Enterprises LLC. All Rights Reserved. 395
Note: Channels may not be removed from a MAC domain while they are in the administrative up state.
These commands assign a user-provisioned channel ID to a downstream or logical upstream channel that has already been
added to a logical MAC domain. If you do not execute this command, the CMTS assigns the default channel IDs.
configure interface cable-downstream <WORD> cable channel-id <INT>
configure interface cable-upstream <WORD> cable channel-id <INT>
The following commands use the default channel IDs:
configure interface cable-downstream 14/0 cable channel-id 1
configure interface cable-downstream 14/1 cable channel-id 2
configure interface cable-downstream 14/2 cable channel-id 3
configure interface cable-downstream 14/3 cable channel-id 4
configure interface cable-downstream 14/4 cable channel-id 1
configure interface cable-downstream 14/5 cable channel-id 2
configure interface cable-downstream 14/6 cable channel-id 3
configure interface cable-downstream 14/7 cable channel-id 4
configure interface cable-downstream 14/8 cable channel-id 1
configure interface cable-downstream 14/9 cable channel-id 2
configure interface cable-downstream 14/10 cable channel-id 3
configure interface cable-downstream 14/11 cable channel-id 4
configure interface cable-downstream 14/12 cable channel-id 1
configure interface cable-downstream 14/13 cable channel-id 2
configure interface cable-downstream 14/14 cable channel-id 3
configure interface cable-downstream 14/15 cable channel-id 4
configure interface cable-upstream 1/0.0 cable channel-id 1
configure interface cable-upstream 1/1.0 cable channel-id 2
configure interface cable-upstream 1/2.0 cable channel-id 3
configure interface cable-upstream 1/3.0 cable channel-id 4
configure interface cable-upstream 1/4.0 cable channel-id 5
configure interface cable-upstream 1/5.0 cable channel-id 6
configure interface cable-upstream 1/6.0 cable channel-id 7
configure interface cable-upstream 1/7.0 cable channel-id 8
configure interface cable-upstream 1/8.0 cable channel-id 9
configure interface cable-upstream 1/9.0 cable channel-id 10
configure interface cable-upstream 1/10.0 cable channel-id 11
configure interface cable-upstream 1/11.0 cable channel-id 12
Note: An assigned upstream channel ID (UCID) must not be assigned to any other logical channel on the 12U or 24U CAM
or MAC domain. An assigned downstream channel ID (DCID) must not be assigned to any other channel in the MAC
domain.
To Next Page
Loading...
