Arris C4C - Configure Router Bgp Neighbor Timers

Chapter 46: Command Line Descriptions
STANDARD Revision 1.0 C4® CMTS Release 8.3 User Guide
© 2016 ARRIS Enterprises LLC. All Rights Reserved. 2416
configure router bgp * neighbor * timers
Purpose
Configures the keepalive and holdtime of the specified neighbor.
Default Access Level
15
Command Syntax
configure router bgp [<int>] neighbor <ipv6> timers <keepalive> <holdtime>
configure router bgp [<int>] neighbor <ipv6> timers [<keepalive>] [<holdtime>] no
Supplemental
Information
To clear the keepalive and holdtime of a specified neighbor, use the no option.
Parameters
[<int>]
Autonomous System (AS) number. Valid range is 1-65535
<ipv6>
IPv6 address
<keepalive>
The frequency (in seconds) that a keepalive message is sent to its peer. Valid range is 0-65535.
<holdtime>
The interval (in seconds) after not receiving a response that a peer is considered dead. Valid range is 0-65535.