Chapter 31: Load Balancing
STANDARD Revision 1.0 C4® CMTS Release 8.3 User Guide
© 2016 ARRIS Enterprises LLC. All Rights Reserved. 902
Number of CMs to check per Interval: 10
Across Mac Domain Check (sec) : 0
show cable load-balance group
Ena- Init Cable
Group bled Policy Tech mCMsg Mac Fiber-Node Type Service Type Id
---------- ---- ---------- --------- ----- ----- ------------- ---------- ------------------
16779264 yes 1 ranging 1 1 1 General -
16781312 yes 1 ranging 2 1 2 General -
show cable load-balance policy
Steering
Thres Disable Registration Periodic Channel
Policy Rule Enabled -hold Method Start Period D2.0 D3.0 D2.0 D3.0 Weight Type
---------- ---------- -------- ----- ------ ------------------ ----- ----- ----- ----- ------- ------------------------
Default(0) - yes 10% modem 00:00:00 00:00:00 - - - - - Static,DCC
1 1 yes 10% util 00:00:00 00:00:00 False False False False equal Static,DCC,B-US-DBC,B-DS-DBC
Key to Types:
DCC : NonBonded DCC
B-DCC : Bonded DCC
B-US-DBC : Bonded Upstream DBC
B-DS-DBC : Bonded Downstream DBC
Example Configuration
The following provides an example of a configuration that uses non-default values. This example enables static and
periodic load balancing for non-bonded modems (via DCC) and bonded modems (both upstream and downstream via
DBC).
configure cable load-balance rule 2 enable
configure cable load-balance rule 2 type static non-bonded-dcc bonded-us-dbc bonded-ds-dbc
configure cable load-balance rule 2 method utilization
configure cable load-balance rule 2 threshold 10
configure cable load-balance downstream-start-threshold 60
configure cable load-balance upstream-start-threshold 60
configure cable load-balance policy 2 rule 2
configure cable load-balance general-group-defaults policy 2
configure cable load-balance general-group-defaults init-technique ranging
configure cable load-balance failed-list timeout 24
configure cable load-balance failed-list exclude-count 2
configure cable load-balance macdomain-check 300
To Next Page
Loading...
Need help?
General
