Arris C4C - Configure Logging Trap

Chapter 46: Command Line Descriptions
STANDARD Revision 1.0 C4® CMTS Release 8.3 User Guide
© 2016 ARRIS Enterprises LLC. All Rights Reserved. 2195
configure logging trap
Purpose
Enables or disables DOCSIS® SNMP traps.
Default Access Level
15
Command Syntax
configure logging trap <modem_activity_option>
configure logging trap <modem_activity_option> no
Supplemental
Information
To disable DOCSIS® traps only, use the no option.
Parameters
<modem_activity_o
ption>
DOCSIS® trap to enable or disable. Options are listed below.
init-reg-req-fail - register request failed trap
init-reg-rsp-fail - register response failed trap
init-reg-ack-fail - register acknowledgement failed trap
dyn-serv-req-fail - dynamic service request failed trap
dyn-serv-rsp-fail - dynamic service response failed trap
dyn -serv-ack-fail - dynamic services ack failed trap
bpi-init - BPI init trap
bpkm - Baseline Privacy Key Management (BPKM) trap
dyn-sa - Dynamic SA trap
dcc-req-fail - DCC request failed trap
dcc-rsp-fail - DCC response failed trap
dcc-ack-fail - DCC ack failed trap