Arris C4C - Configure Interface Tengigabitethernet Isis Priority

Chapter 46: Command Line Descriptions
STANDARD Revision 1.0 C4® CMTS Release 8.3 User Guide
© 2016 ARRIS Enterprises LLC. All Rights Reserved. 2056
configure interface tengigabitethernet * isis priority
Purpose
Configures the priority of the designated routers for the specified interface.
Default Access Level
15
Command Syntax
configure interface tengigabitethernet <slot>/<port>[.<0-254>] isis priority <priority> [<level1 |
level2>]
configure interface tengigabitethernet <slot>/<port>[.<0-254>] isis priority [<level1 | level2>] no
Supplemental
Information
The priority is used to determine which router on a LAN will be the designated router. The priorities are advertised in the hello
packets. The router with the highest priority will become the Designated Intermediate System (DIS). In the case of equal priorities,
the highest MAC address breaks the tie.
To restore the default value, use the no option.
Parameters
<slot>/<port>[.<0-
254>]
RCM slot number/tengigabitEthernet port number[.subinterface number].
Valid range for the C4 CMTS is <17-18>/<10>[.<0-254>]
Valid range for the C4c CMTS is <17>/<10>[.<0-254>]
<priority>
Sets the priority value of a router and is a number from 0 to 127. The default value is 64.
[<level1 | level2>]
Specifies the type of adjacencies to be formed on this interface. If no value is specified, then modify value for both level-1 and level-
2.