Arris C4C - Page 488

Chapter 16: Dynamic Routing Protocols
STANDARD Revision 1.0 C4® CMTS Release 8.3 User Guide
© 2016 ARRIS Enterprises LLC. All Rights Reserved. 488
Purpose
Command
configure interface tengigabitethernet <WORD> ip router isis
[no]
configure interface tengigabitethernet <WORD> ipv6 router isis
[no]
Configures the IS-IS authentication for LSPs.
configure interface cable <WORD> isis authentication key-chain
[no]
configure interface cable-mac <WORD> isis authentication
key-chain [no]
configure interface gigabitethernet <WORD> isis authentication
key-chain [no]
configure interface tengigabitethernet <WORD> isis
authentication key-chain [no]
Configures the IS-IS authentication mode for
LSPs.
configure interface cable <WORD> isis authentication mode [no]
configure interface cable-mac <WORD> isis authentication mode
[no]
configure interface gigabitethernet <WORD> isis authentication
mode [no]
configure interface tengigabitethernet <WORD> isis
authentication mode [no]
Configures the level of adjacency for the
specified interface. The Level 1 adjacency may
be established if there is at least one area
address in common between this system and
its neighbors.
configure interface cable <WORD> isis circuit-type [no]
configure interface cable-mac <WORD> isis circuit-type [no]
configure interface gigabitethernet <WORD> isis circuit-type
[no]
configure interface tengigabitethernet <WORD> isis circuit-type
[no]
Configures the complete sequence number
PDUs (CSNPs) interval for the specified
interface. This command only applies to the
designated router on the specified interface.
configure interface cable <WORD> isis csnp-interval [no]
configure interface cable-mac <WORD> isis csnp-interval [no]
configure interface gigabitethernet <WORD> isis csnp-interval
[no]
configure interface tengigabitethernet <WORD> isis csnp-interval
[no]
Configures the length of time in milliseconds
between hello packets for the specified
interface when it is DIS.
configure interface cable <WORD> isis ds-hello-interval [no]
configure interface cable-mac <WORD> isis ds-hello-interval [no]
configure interface gigabitethernet <WORD> isis
ds-hello-interval [no]
configure interface tengigabitethernet <WORD> isis
ds-hello-interval [no]
Computes the hello interval based on the hello
multiplier so that the resulting hold time is 1
second.
configure interface cable <WORD> isis hello-interval [no]
configure interface cable-mac <WORD> isis hello-interval [no]
configure interface gigabitethernet <WORD> isis hello-interval
[no]