Arris C4C - Page 489

Chapter 16: Dynamic Routing Protocols
STANDARD Revision 1.0 C4® CMTS Release 8.3 User Guide
© 2016 ARRIS Enterprises LLC. All Rights Reserved. 489
Purpose
Command
configure interface tengigabitethernet <WORD> isis
hello-interval [no]
Computes the hello interval based on the hello
multiplier so that the resulting hold time is 1
second.
configure interface cable <WORD> isis hello-interval minimal
configure interface cable-mac <WORD> isis hello-interval minimal
configure interface gigabitethernet <WORD> isis hello-interval
minimal
configure interface tengigabitethernet <WORD> isis
hello-interval minimal
Configures the number of IS-IS hello packets a
neighbor must miss before the router declares
the neighbor to be down on the specified
interface. This time determines how quickly a
failed neighbor is detected so that routes can
be recalculated.
configure interface cable <WORD> isis hello-multiplier [no]
configure interface cable-mac <WORD> isis hello-multiplier [no]
configure interface gigabitethernet <WORD> isis hello-multiplier
[no]
configure interface tengigabitethernet <WORD> isis
hello-multiplier [no]
Configures the time delay between successive
LSPs for the specified interface.
configure interface cable <WORD> isis lsp-interval [no]
configure interface cable-mac <WORD> isis lsp-interval [no]
configure interface gigabitethernet <WORD> isis lsp-interval
[no]
configure interface tengigabitethernet <WORD> isis lsp-interval
[no]
Configures the maximum packet size of LSPs
for the specified interface.
configure interface cable <WORD> isis lsp-mtu [no]
configure interface cable-mac <WORD> isis lsp-mtu [no]
configure interface gigabitethernet <WORD> isis lsp-mtu [no]
configure interface tengigabitethernet <WORD> isis lsp-mtu [no]
Configures the default metric for the specified
interface.
Note: the loopback interface is always passive.
configure interface cable <WORD> isis metric [no]
configure interface cable-mac <WORD> isis metric [no]
configure interface loopback <INT> isis metric [no]
configure interface gigabitethernet <WORD> isis metric [no]
configure interface tengigabitethernet <WORD> isis metric [no]
Configures the metric for the MT #2 IPv6
topology.
configure interface gigabitethernet <WORD> isis ipv6 metric
<metric> [no]