Chapter 15: Interface IP Configuration
STANDARD Revision 1.0 C4® CMTS Release 8.3 User Guide
© 2016 ARRIS Enterprises LLC. All Rights Reserved. 452
Display minimum information about the LACP
protocol. (Shows protocol settings, counts, and
status for one or all gigabit Ethernet ports.) For
each gigabitEthernet link running LACP, the show
lacp counters command shows:
LACP PDUs sent
LACP PDUs received
LACP PDU errors
For each gigabitEthernet link running LACP, the
show lacp internal and show lacp
partner commands show the following for the
local actor and for the partner, respectively:
LACP flags (fast/slow, active/passive)
LACP state
Port priority
Port Operational state
Port ID
Port state
show lacp [gigab
itEthernet <slot>/<port>]
[{counters | internal
| partner | sys-id}]
Display routing information for the LAG port:
show interface link-aggregate <>
show ip igmp groups detail link-aggregate <WORD>
show ip igmp groups host link-aggregate <WORD>
show ip igmp interfaces link-aggregate <WORD>
show ip interface [brief] link-aggregate [<WORD>]
show ipv6 interface [brief] link-aggregate [<WORD>]
show ipv6 neighbors link-aggregate <WORD>
show ipv6 ospf interface [brief] link-aggregate [<WORD>]
show ipv6 ospf neighbor [detail] link-aggregate <WORD>
To Next Page
Loading...
Need help?
General
