Arris C4C - Page 518

Chapter 16: Dynamic Routing Protocols
STANDARD Revision 1.0 C4® CMTS Release 8.3 User Guide
© 2016 ARRIS Enterprises LLC. All Rights Reserved. 518
Purpose
Command
Configures the interval after which a neighbor is declared
dead when no hello packets are seen on the specified
interface.
configure interface {cable <word> | cable-mac <word> |
gigabitethernet <word> | tengigabitethernet <word>}
ipv6 ospf dead-interval [<int>] [no]
Configures the interval between hello packets sent on the
specified interface.
configure interface {cable <word> | cable-mac <word> |
gigabitethernet <word> | tengigabitethernet <word>}
ipv6 ospf hello-interval [<int>] [no]
Configures whether the OSPFv3 router process checks if
neighbors are using the same maximum transmission unit
(MTU) on the specified interface when exchanging data
base descriptor (DBD) packets.
configure interface {cable <word> | cable-mac <word> |
gigabitethernet <word> | tengigabitethernet <word>}
ipv6 ospf mtu-ignore [no]
Configures the OSPF network type to a type other than
the default for a given media. Current supported type is
broadcast or point-to-point.
configure interface {cable <word> | cable-mac <word> |
gigabitethernet <word> | tengigabitethernet <word>}
ipv6 ospf network <list> [no]
Configures the router priority on the specified OSPFv3
interface.
configure interface {cable <word> | cable-mac <word> |
gigabitethernet <word> | tengigabitethernet <word>}
ipv6 ospf priority <int> [no]
Configures the time between link-state advertisement
(LSA) retransmissions for adjacencies belonging to the
specified OSPFv3 interface.
configure interface {cable <word> | cable-mac <word> |
gigabitethernet <word> | tengigabitethernet <word>}
ipv6 ospf retransmit-interval <int> [no]
Configures the estimated time required to send a link-
state update packet on the specified OSPFv3 interface.
configure interface {cable <word> | cable-mac <word> |
gigabitethernet <word> | tengigabitethernet <word>}
ipv6 ospf transmit-interval <int> [no]
Show Commands:
Displays the route redistributions.
show ipv6 ospf <word>
Displays the OSPF area information.
show ipv6 ospf area
Displays the OSPF database information.
show ipv6 ospf database