Chapter 18: Baseline Privacy Interface (BPI)
STANDARD Revision 1.0 C4® CMTS Release 8.3 User Guide
© 2016 ARRIS Enterprises LLC. All Rights Reserved. 592
Using the show log history command, a log entry is displayed as follows:
15:45:25 11 notc: MAC=00:18:68:92:29:be;
CA Certificate being dropped.
Using the show log history detail command, the event ID is captured in the log entry as follows:
04/02/13 13:25:31 [11.0000000103] <2473076488> (notc) MAC=5c:57:1a:45:79:52; CA Certificate
being dropped.
Use the following command to toggle the TRUE/FALSE setting of the cadUpchannelCaCertDropEnable MIB object:
configure [no] cable privacy ca-bad-cert-drop
Use the following command to display the Drop Bad BPI Certificates setting associated with the
cadUpchannelCaCertDropEnable MIB object:
show cable global-settings
An output similar to what is shown in the following example will be output:
Annex: annex B
Downstream Frequency Range: 91-867
Upstream Frequency Range: 5-42
Allow piggybacking data req on polling US SFs: Disabled
Load Balance: Enabled
CM registration request Timeout: 30
Maximum QoS Active Timeout: 30
Maximum QoS Admitted Timeout: 200
Concatenation for DOCSIS 1.0 CM: Off
Fragmentation for DOCSIS 1.0 CM: On
Max traffic burst for 1.1 CM: 790000
Peak traffic rate for 1.1 CM: 0
Percent increase for DS SF rate: 1
CMs required to detect US lockup: 10
LO1 leak detect: Enabled
Interval to collect utilization data: 300
Modifying primary DS chan in RCC of Reg-Rsp-Mp: Disabled
Send 46.1RefID only in first TCC frag: False
Allow CM service group ambiguity override: Disabled
Unicast non-primary US channel acquisition: Disabled
TFTP Enforce and Dynamic Shared Secret: Enabled
Drop Bad BPI Certificates: Enabled
To Next Page
Loading...
