Chapter 20: CPE Device Classes
STANDARD Revision 1.0 C4® CMTS Release 8.3 User Guide
© 2016 ARRIS Enterprises LLC. All Rights Reserved. 656
Note: The show commands that specify cpe-type show only those modems that actually have CPE devices of that kind
registered behind them. If you specify “stb” in the show command and there are no modems that have STB CPE devices
registered behind them, then the system response does not return any modems.
When a CPE type is specified, the show cable modem will display only the CMs that match the given criteria, in other
words, those
modems with the given CPE type registered behind that modem. The format of the display is the same as that of the
normal show
cable modem command.
The following is an example:
# show cable modem cpe-type stb
Jun 4 14:03:33
Interface DOC
(DS-US) Mac Bonded State SIS Qos CPE MAC address IP Address
------------- ----- ------ ----------- --- ----------- --- --------------- -----------------------
Total Oper Disable Init Offline
----------------------------------------------------------------
Found 0 0 0 0 0
No CMs were found that match the specified criteria:
CPEs of type: ( stb )
To Next Page
Loading...
Need help?
General
