Arris C4C - Page 2671

Chapter 46: Command Line Descriptions
STANDARD Revision 1.0 C4® CMTS Release 8.3 User Guide
© 2016 ARRIS Enterprises LLC. All Rights Reserved. 2671
cpe-ipv6
Filter on IPv6 address of CPE under the CM.
cpe-mac
Filter on MAC address of CPE under the CM.
cpe-type
Filter by Customer Premise Equipment type: CPE, MTA, set-top box (STB), or
PS.
l2vpnId
Filter CMs on l2vpn id.
Group Match
bonded
Filter on bonded CMs.
bonded-impaired
Filter on bonded CMs that are not functioning at full capacity.
bonded-1x1
Filters on D3.0 capable CMs not functioning as bonded CMs.
cable-downstream (s/p)
Filter on downstream interface.
cable-mac (x)
Filter on MAC Identifier (1-416).
cable-upstream (s/p.l)
Filter on upstream interface.
cm-ip-type
Filter on CM’s IP address type: IPv4 or IPv6.
cm-type <type>
Filter by modem type std (on-flexpath), ccm (each flexpath channel) or fpcm
(master flexpath id).
em1x1mode-capable
Filter on CMs capable of Energy Management 1x1 mode operation