Arris C4C - Page 491

Chapter 16: Dynamic Routing Protocols
STANDARD Revision 1.0 C4® CMTS Release 8.3 User Guide
© 2016 ARRIS Enterprises LLC. All Rights Reserved. 491
Purpose
Command
Configure filtering for outbound BGP routes on
the specified VRF for the ISIS routing process.
configure router bgp [<INT>] distribute-list <1-99> out isis
Configure redistribution of routes from IS-IS
routing processes into a BGP autonomous
system.
configure router bgp [<int>] redistribute isis
Places the system into an intermediate mode.
NOTE: Use the NO command to remove all the
IS-IS configuration.
configure router isis [no]
Allows user to enter CLI address family IPv4
mode.
configure router isis address-family ipv4
Enables IS-IS routing for IP on the router level
configure router isis address-family ipv4 enable [no]
Allows user to enter CLI address family IPv6
mode.
configure router isis address-family ipv6
Enables IS-IS routing for IPv6 on the router
level.
configure router isis address-family ipv6 enable [no]
Configures the router IS-IS authentication key-
chain.
configure router isis authentication key-chain [no]
Configures the router IS-IS authentication
mode.
configure router isis authentication mode [no]
Configures administrative distance for IS-IS
routes.
configure router isis distance [no]
Configures administrative distance for subsets
of the IS-IS routes in the same VRF.
configure router isis distance isis [no]
Configure filtering for outbound IS-IS routes in
the same VRF.
configure router isis distribute-list <num> out [no]
Configures the number of equal costs routes.
configure router isis ecmp [no]