Arris C4C - Page 492

Chapter 16: Dynamic Routing Protocols
STANDARD Revision 1.0 C4® CMTS Release 8.3 User Guide
© 2016 ARRIS Enterprises LLC. All Rights Reserved. 492
Purpose
Command
Modifies the graceful-restart parameters for
IS-IS to help the peer to restart.
configure router isis graceful-restart help-peer [no]
Modifies the graceful-restart parameters for
IS-IS to wait the specified time to establish
adjacencies before completing the
start/restart. Use the second command to
negate the wait time.
configure router isis graceful-restart interface wait <INT>
configure router isis graceful-restart interface [no]
Modifies the graceful-restart parameters for
IS-IS for the maximum time before completing
the restart procedures.
configure router isis graceful-restart t3 <INT> [no]
Configures the routing level.
configure router isis is-type [no]
Configures the generation rate of the LSPs.
configure router isis lsp-gen-interval [no]
Configures the link-state-packet (LSP) refresh
interval.
configure router isis lsp-refresh-interval [no]
Configures the maximum time that link-state-
packets (LSPs) can remain in a router’s
database without being refreshed.
configure router isis max-lsp-lifetime [no]
Configures the type of metric the C4/c CMTS
will generate or accept.
configure router isis metric-style <narrow | transition | wide>
Configures an IS-IS network entity title (NET).
NETs define the area addresses for the IS-IS
area and the system ID of the router.
configure router isis net [no]
Suppresses routing updates on the specified
interface.
Note: the loopback interface is always passive.
configure router isis passive-interface cable <WORD> [no]
configure router isis passive-interface cable-mac <WORD> [no]
configure router isis passive-interface loopback <INT> [no]
configure router isis passive-interface gigabitethernet <WORD>
[no]
configure router isis passive-interface tengigabitethernet
<WORD> [no]