Arris C4C - Page 494

Chapter 16: Dynamic Routing Protocols
STANDARD Revision 1.0 C4® CMTS Release 8.3 User Guide
© 2016 ARRIS Enterprises LLC. All Rights Reserved. 494
Purpose
Command
Configure redistribution routes from
Intermediate System-to-Intermediate System
(IS-IS) routing processes into OSPF.
configure router ospf [vrf <name>] redistribute isis [no]
Configure filtering for outbound RIP routes on
the specified VRF for the IS-IS routing process.
configure router rip [vrf <name>] distribute list <WORD> out
isis [no]
Configure redistribution routes from IS-IS
routing processes into RIP.
configure router rip [<int>] [vrf <name>] redistribute isis [no]
Display the IS-IS redistribution information.
show distribute-list
Displays the IS-IS redistribution information.
show ip isis
show ipv6 isis
Displays the IPv4 / IPv6 IS-IS route information.
show ip route isis
show ipv6 route isis
Displays IS-IS link state database for the
specified VRF.
show isis database
Displays IS-IS interface status and
configuration for the specified VRF.
show isis interface
Displays IS-IS events specific to a circuit and
level for the specified VRF.
show isis interface events
Displays CLNS neighbor adjacencies for the
specified VRF.
show isis neighbor [detail]
Displays CLNS protocol information for the
specified VRF.
show isis protocol
Displays IS-IS protocol statistics for the
specified VRF.
show isis traffic
Enables tracing of IS-IS router events to the
logging history.
trace logging router isis [no]