Document revision history RM0046
928/936 Doc ID 16912 Rev 5
30-Jun-2010 2
33, “Boot Assist Module (BAM)
Minor editorial and formatting changes
Section 33.3, “Boot modes: Minor editorial changes
Section 33.5.1, “Entering boot modes: Editorial changes
Boot mode selection: Added Autobaud Scan boot mode
Section 33.5.3, “Reset Configuration Half Word (RCHW): Removed the word “Source”
from title
Section , “UART boot mode download protocol: Modified title; editorial changes
Section 33.6, “FlexCAN boot mode download protocol: Modified title; editorial changes in
several subsections
34, “Voltage Regulators and Power Supplies
Section 34.1, “Voltage regulator: Replaced “The internal voltage regulator requires an
external capacitance (CREG)” with “The internal voltage regulator requires an external
ballast transistor and (external) capacitance (CREG)”
Section 34.1.2, “Low Voltage Detectors (LVD) and Power On Reset (POR): Removed
sentence “The other LVD_DIG is placed in the standby domain and senses the standby
1.2 V supply level notifying that the 1.2 V output is stable.”
Voltage Regulator Control register (VREG_CTL): Changed reset values of register bits 23
and 27
Voltage Regulator Status register (VREG_STATUS): Changed reset values of register bits
23 and 27
Section 34.2, “Power supply strategy:
– Updated description of bullet “LV—Low voltage internal power supply”
– Removed bullet “BV—High voltage supply for voltage regulator ballast” and associated
description
35, “IEEE 1149.1 Test Access Port Controller (JTAGC): Unchanged from previous
revision
36, “Nexus Development Interface (NDI)
Minor editorial and formatting changes
Replaced several references to “Zen” with “e200z0h” throughout chapter
Replaced several references to PowerPC with references to Power Architecture™
Section 36.2.1, “Features not supported: Replaced “Nexux3” with “Nexus3”
IEEE 1149.1-2001 TAP Controller State Machine: Added figure title and inserted note
Appendix A, “Registers Under Protection: Unchanged from previous revision
Table 476. Revision history (continued)
Date Revision Changes