IP Configuration Command Set
Reviewing IP Traffic and Configuring Routes
Matrix DFE-Platinum and Diamond Series Configuration Guide 12-47
12.2.6.10 ping
Use this command to test routing network connectivity by sending IP ping requests. The ping utility
(IP ping only) transmits a maximum of five echo requests, with a packet size of 100. The application
stops when the response has been received, or after the maximum number of requests has been sent.
ping ip-address
Syntax Description
Command Type
Router command.
Command Mode
Privileged EXEC: Matrix>Router1#
Command Defaults
None.
Examples
This example shows output from a successful ping to IP address 182.127.63.23:
This example shows output from an unsuccessful ping to IP address 182.127.63.24:
ip-address Specifies the IP address of the system to ping.
Matrix>Router1#ping 182.127.63.23
Reply from 182.127.63.23
Reply from 182.127.63.23
Reply from 182.127.63.23
------ PING 182.127.63.23 : Statistics ------
3 packets transmitted, 3 packets received, 0% packet loss
Matrix>Router1#ping 182.127.63.24
Timed Out
Timed Out
Timed Out
------ PING 182.127.63.24 : Statistics ------
3 packets transmitted, 0 packets received, 100% packet loss
To Next Page
Loading...
Need help?
General