Enterasys Matrix 2G4072-52 - Show Igmp Protocols

IGMP Configuration Command Set
Configuring IGMP
10-22 Matrix DFE-Platinum and Diamond Series Configuration Guide
10.4.2.13 show igmp protocols
Use this command to display the binding of IP protocol id to IGMP classification
show igmp protocols
Command Defaults
None.
Command Type
Switch command.
Command Mode
Read-Only.
Example
This example shows how to display the
binding of IP protocol id to IGMP classification:
Matrix(rw)->show igmp protocols
Protocol Classifications
Protocol Ids set to Mcast Data
17
Protocol Ids set to routing Protocol
3,7-9,42-43,45,47-48,85-86,88-89,91-92,100,103,112
Protocol Ids set to Ignore
0,4-6,10-16,18-41,44,46,49-84,87,90,93-99,101-102,104-111,113-255