Port Configuration Command Set
Configuring Link Traps and Link Flap Detection
Matrix DFE-Platinum and Diamond Series Configuration Guide 4-79
4.3.8.9 set linkflap threshold
Use this command to set the link flap action trigger count.
set linkflap threshold port-string threshold_value
Syntax Description
Command Defaults
None.
Command Type
Switch command.
Command Mode
Read-Write.
Examples
This example shows how to set the link flap threshold on port fe.1.4 to 5:
port-string Specifies the port(s) on which to set the link flap action
trigger count. For a detailed description of possible
port-string values, refer to Section 4.1.1.
threshold_value Specifies the number of link down transitions necessary to
trigger the link flap action.
Matrix(rw)->set linkflap threshold fe.1.4 5
To Next Page
Loading...
