EasyManuals Logo

Enterasys Matrix 2G4072-52 User Manual

Enterasys Matrix 2G4072-52
1422 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #820 background imageLoading...
Page #820 background image
Logging And Network Management Command Set
Monitoring Network Events and Status
11-30 Matrix DFE-Platinum and Diamond Series Configuration Guide
11.2.2.4 show netstat
Use this command to display statistics for the switch’s active network connections.
show netstat [icmp | ip | routes | stats | tcp | udp]
Syntax Description
Command Defaults
If no parameters are specified, show netstat will be executed as shown in the
example below.
Command Type
Switch command.
Command Mode
Read-Only.
Example
This example shows how to display statistics for all the current active network connections:
icmp (Optional) Shows Internet Control Message Protocol
(ICMP) statistics.
ip (Optional) Shows Internet Protocol (IP) statistics.
routes (Optional) Shows the IP routing table.
stats (Optional) Shows all statistics for TCP, UDP, IP, and
ICMP.
tcp (Optional) Shows Transmission Control Protocol (TCP)
statistics.
udp (Optional) Shows User Datagram Protocol (UDP)
statistics.
Matrix(rw)->show netstat
Active Internet connections (including servers)
PCB Proto Recv-Q Send-Q Local Address Foreign Address (state)
-------- ----- ------ ------ ------------------ ------------------ -------
1cc6314 TCP 0 0 0.0.0.0.80 0.0.0.0.0 LISTEN
1cc6104 TCP 0 0 0.0.0.0.23 0.0.0.0.0 LISTEN
1cc6290 UDP 0 0 0.0.0.0.162 0.0.0.0.0
1cc620c UDP 0 0 0.0.0.0.161 0.0.0.0.0

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Enterasys Matrix 2G4072-52 and is the answer not in the manual?

Enterasys Matrix 2G4072-52 Specifications

General IconGeneral
BrandEnterasys
ModelMatrix 2G4072-52
CategorySwitch
LanguageEnglish

Related product manuals