Enterasys Matrix 2G4072-52 - Show Nodealias Config

Logging And Network Management Command Set
Configuring Node Aliases
11-146 Matrix DFE-Platinum and Diamond Series Configuration Guide
11.2.7.4 show nodealias config
Use this command to display node alias configuration settings on one or more ports.
show nodealias config [port-string]
Syntax Description
Command Defaults
If port-string is not specified, node alias configurations will be displayed for all
ports.
Command Mode
Read-Only.
Example
This example shows how to display node alias configuration settings for ports fe.2.1 through 9:
Table 11-16 provides an explanation of the command output.
port-string (Optional) Displays node alias configuration settings for
specific port(s). For a detailed description of possible
port-string values, refer to Section 4.1.1.
Matrix(rw)->show nodealias config fe.2.1-9
Port Number Max Entries Used Entries Status
----------- ----------- ------------ ------
fe.2.1 16 0 Enabled
fe.2.2 47 0 Enabled
fe.2.3 47 2 Enabled
fe.2.4 47 0 Enabled
fe.2.5 47 0 Enabled
fe.2.6 47 2 Enabled
fe.2.7 47 0 Enabled
fe.2.8 47 0 Enabled
fe.2.9 4000 1 Enabled