General Configuration Command Set
Resetting the Device
2-156 Matrix DFE-Platinum and Diamond Series Configuration Guide
2.2.12.5 clear config
Use this command to clear the user-defined switch and router configuration parameters for one or
more modules. Executing clear config on one Matrix module resets that module back to its factory
defaults. If that module is in a chassis with other active modules, it will inherit system settings from
the system. For a list of factory device default settings, refer to Section 2.1.1.
clear config mod-num | all
Syntax Description
Command Defaults
None.
Command Mode
Read-Write.
Example
This example shows how to clear configuration parameters in all modules:
NOTE: This command will not affect the IP address.
mod-num | all Clears configuration parameters in a specific module or in
all modules.
Matrix(rw)->clear config all
To Next Page
Loading...
Need help?
General