Spanning Tree Configuration Command Set
Configuring Spanning Tree Port Parameters
6-118 Matrix DFE-Platinum and Diamond Series Configuration Guide
6.2.2.26 clear spantree adminpoint
Use this command to reset the administrative point-to-point status of the LAN segment attached to
a Spanning Tree port to auto mode.
clear spantree adminpoint port-string
Syntax Description
Command Defaults
None.
Command Type
Switch command.
Command Mode
Read-Write.
Example
This example shows how to reset point-to-point status to auto on fe.2.3:
port-string Specifies port(s) on which to reset point-to-point protocol
status. For a detailed description of possible port-string
values, refer to Section 4.1.1.
Matrix(rw)->clear spantree adminpoint fe.2.3
To Next Page
Loading...
