Security Configuration Command Set
Configuring Access Lists
Matrix DFE-Platinum and Diamond Series Configuration Guide 14-159
14.3.12Configuring Access Lists
Purpose
To review and configure security access control lists (ACLs), which permit or deny access to
routing interfaces based on protocol and source IP address restrictions.
Commands
The commands used to review and configure security access lists are listed below and described in
the associated section as shown:
• show access-lists (Section 14.3.12.1)
• access-list (standard) (Section 14.3.12.4)
• access-list (extended) (Section 14.3.12.3)
• ip access-group (Section 14.3.12.4)
ROUTER: These commands can be executed when the device is in router mode only.
For details on how to enable router configuration modes, refer to Section 2.3.3.
To Next Page
Loading...
