Spanning Tree Configuration Command Set
Configuring Spanning Tree Bridge Parameters
Matrix DFE-Platinum and Diamond Series Configuration Guide 6-39
6.2.1.26 clear spantree priority
Use this command to reset the Spanning Tree priority to the default value of 32768.
clear spantree priority [sid]
Syntax Description
Command Defaults
If sid is not specified, priority will be reset on Spanning Tree 0.
Command Type
Switch command.
Command Mode
Read-Write.
Example
This example shows how to reset the bridge priority on SID 1:
sid (Optional) Resets the priority on a specific Spanning
Tree. Valid values are 0 - 4094. If not specified, SID
0 is assumed.
Matrix(rw)->clear spantree priority 1
To Next Page
Loading...
