Logging And Network Management Command Set
Configuring Node Aliases
Matrix DFE-Platinum and Diamond Series Configuration Guide 11-149
11.2.7.6 set nodealias maxentries
Use this command to set the maximum number of node alias entries allowed for one or more ports.
set nodealias maxentries val port-string
Syntax Description
Command Defaults
None.
Command Type
Switch command.
Command Mode
Read-Write.
Example
This example shows how to set the maximum node alias entries to 1000 on fe.1.3
:
val Specifies the maximum number of alias entries.
port-string Specifies the port(s) on which to set the maximum entry
value. For a detailed description of possible port-string
values, refer to Section 4.1.1.
Matrix(rw)->set nodealias maxentries 1000 fe.1.3
To Next Page
Loading...
