EasyManuals Logo

Enterasys Matrix 2G4072-52 User Manual

Enterasys Matrix 2G4072-52
1422 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #1333 background imageLoading...
Page #1333 background image
Security Configuration Command Set
Configuring MAC Locking
Matrix DFE-Platinum and Diamond Series Configuration Guide 14-123
14.3.9.3 set maclock enable
Use this command to enable MAC locking on one or more ports. When enabled and configured for
a specific MAC address and port string, this locks a port so that only designated end station
addresses are allowed to participate in frame relay.
set maclock enable [port_string]
Syntax Description
Command Defaults
If port_string is not specified, MAC locking will be enabled on all ports.
Command Type
Switch command.
Command Mode
Read-Write.
Example
This example shows how to enable MAC locking on fe.2.3:
NOTE: MAC locking is disabled by default at device startup. Configuring one or more
ports for MAC locking requires globally enabling it on the device and then enabling it on
the desired ports as described in Section 14.3.9.5.
port_string (Optional) Enables MAC locking on specific port(s). For
a detailed description of possible port_string values, refer
to Section 4.1.1.
Matrix(rw)->set maclock enable fe.2.3

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Enterasys Matrix 2G4072-52 and is the answer not in the manual?

Enterasys Matrix 2G4072-52 Specifications

General IconGeneral
BrandEnterasys
ModelMatrix 2G4072-52
CategorySwitch
LanguageEnglish

Related product manuals