Enterasys Matrix 2G4072-52 - Clear Flowlimit Notification Interval

Security Configuration Command Set
Configuring Flow Setup Throttling (FST)
Matrix DFE-Platinum and Diamond Series Configuration Guide 14-205
14.3.15.12clear flowlimit notification interval
Use this command to reset the SNMP flow limit notification interval to the default value of 120
seconds.
clear flowlimit notification interval
Syntax Description
None.
Command Type
Switch command.
Command Mode
Read-Write.
Command Defaults
None.
Example
This example shows how to reset the SNMP flow limit notification interval:
Matrix(rw)->clear flowlimit notification interval